Option Menu - Hitachi ED-D10N User Manual

OPTION menu

From the OPTION menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons,
and press the ► cursor (or the ENTER) button to
execute the item, except for the items LAMP TIME
and FILTER TIME. Then perform it according to the
following table.
Item
AUTO SEARCH
DIRECT
POWER ON
(continued on next page)
Using the ▲/▼ cursor buttons turns on/off the automatic signal
search function.
ON ó OFF
When the ON is selected, detecting no signal automatically cycles
through input ports in the following order. The search is started from
the current port. Then when an input is found, the projector will stop
searching and display the image.
COMPUTER IN1 ð COMPUTER IN2 ð HDMI
VIDEO  S-VIDEO
Using the ▲/▼ cursor buttons turns on/off the DIRECT POWER
ON function.
ON ó OFF
When set to the ON, the lamp in projector will be automatically
turned on without the usual procedure (17), only when the
projector is supplied with the power after the power was cut while
the lamp was on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
• After turning the lamp on by the DIRECT POWER ON function,
if neither input nor operation is detected for about 30 minutes, the
projector is turned off, even though the AUTO POWER OFF function
(48) is disabled.
Description
OPTION menu
47