Operations; Switching The Power Supply On/Off - Hitachi PJLC2001 User Manual

OPERATIONS

Please read this manual, and the separate "SAFETY INSTRUCTIONS" thoroughly before
using the equipment. Always ensure that the equipment is used safely.

Switching the Power Supply ON/OFF

Switching Power ON
1. Check that the power cord is connected correctly.
2. Set the power switch to [ | ]. The standby mode is selected, and the Power indicator is turned to
orange.
3. Press the STANDBY/ON
Power indicator blinks in green.
4. The Power indicator ceases blinking and turns to green when power is ON. Open the lens door.
5. Adjust picture size using the projection lens Zoom Knob.
6. Adjust focus using the projection lens Focus Ring.
POWER Indicator
Power Switch
Switching Power OFF
1. Press the STANDBY/ON button on the control panel or the remote for approximately two
second. The projector lamp is extinguished and lamp cooling begins. The Power indicator blinks
orange during lamp cooling. Pressing the STANDBY/ON
Power indicator is blinking.
2. The system assumes the Standby mode when cooling is complete, and the Power indicator ceases
blinking and changes to orange. Check that the indicator is orange and set the Power switch to
[O].
3. The Power indicator is extinguished when power is OFF. Do not forget to close the lens door.
Except in emergencies, do not switch power OFF unless the Power indicator is orange as
it will reduce the life of the projector lamp.
ENGLISH-8
button on the control panel or the remote. Warm-up begins and the
STANDBY/ON Button
Slide Lens door
STANDBY/
ON Button
ZOOM knob
FOCUS ring
button has no effect while the
STANDBY/ON VIDEO RGB
MENU
SELECT
MENU RESET
POSITION
MAGNIFY
FREEZE VOLUME