Table of Contents
Advertisement
INSTALLING THE
CD PLAYER
Use this output
BALANCED OUT
ANALOGUE OUT
DIGITAL OUT
AUX DIGITAL OUT
Use this output
ANALOGUE IN A1 (Radio),
A2 (TV), A3 (Cable), A4 (Tape),
A5 (VCR1), A6 (VCR2)
DIGITAL INPUT D1 (DVD), D2
(Aux), D3 (Disc)
OPTICAL INPUT O1 (Sat), O2
(Game)
Use this connection
MERIDIAN COMMS
RS232 connection
TRIGGER OUTPUT 1, 2, 3
Audio outputs
Audio inputs (808i only)
To connect to this
The analogue outputs of a source, such as a TV or tape deck.
The digital output of a source such as a DVD player.
The optical output of a source such as a satellite receiver.
The default assignment of the source to each input is shown in brackets
after the input name in the above table. CD corresponds to the internal CD
player.
Communications connections
To connect to this
Other Meridian G Series, 500 Series, or 800 Series equipment,
or Meridian DSP loudspeakers.
A computer, for confi guring the CD player.
Equipment that can be triggered by a 12V 100mA signal.
To enable or disable the AUX output
• Switch the CD player to standby.
• Hold down Repeat (under the front panel).
The display switches between:
and:
To connect to this
The balanced analogue inputs of a preamplifi er, or a power
amplifi er such as the G57, using XLR leads.
The unbalanced analogue inputs of a preamplifi er, or a power
amplifi er such as the G57, using analogue phono leads.
The digital input of a surround processor, such as the 861
Reference Digital Surround Controller, or DSP loudspeakers,
Ω
using a 75
digital cable.
The digital input of an additional surround processor or a pair
of DSP loudspeakers, when the main output is being used. For
highest sound quality the AUX output is not always available;
see To enable or disable the AUX output below.
23
AUX always available
192k direct to DAC
Advertisement
Table of Contents
