Mark Levinson 32 Owner's Manual page 61

Nº32 Reference Preamplifier
master
communication
port
slave in amplifier
input control
2. Make sure the Nº32 and all associated components are powered
off.
3. Make Link connections while referring to Table 4-2 on page 4-
16 and Figure 4-2. In general, components must be linked as
follows: digital audio processor, to digital transport(s), to Nº32,
to power amplifier(s).
Figure 4-2: Sample slave chains.
N°360S
Digital Audio Processor
Step A:
Connect the digital audio processor master
port to the digital transport slave in port.
N°32
Reference Preamplifier
Step B:
Connect the Nø32 amplifier communication
port to the first power amplifier input
port.
Nº436
Power Amplifier
Step C:
Connect the first power amplifier
control port to the second power amplifier
input port. If no additional power
amplifiers are included in the slave chain,
the last power amplifier control port
is not connected.
4. When Link connections have been made, power on linked
components ONE AT A TIME in the order specified below.
Allow each component to complete its initialization sequence
before proceeding to the next component.
A. Digital Audio Processor
B. Digital Transport(s)
C. Nº32
D. Power Amplifier(s)
At this point, the front panel standby LEDs on all linked
components should be blinking in unison.
Note that linked components must be powered on ONE AT A
TIME in the order specified above to ensure proper functioning
N°360S
Digital Audio Processor
master Step A:
communication
Connect the digital audio processor master
port
port to the digital transport slave in port.
N°37
slave in slave out
Digital Transport
Step B:
Connect the digital transport slave out port
to the Nø32 slave in port.
N°32
Reference Preamplifier
Step C:
slave in amplifier
Connect the Nø32 amplifier communication
port to the first power amplifier
port.
input control N°436
Power Amplifier
Step D:
Connect the first power amplifier
control port to the second power amplifier
input port. If no additional power
amplifiers are included in the slave chain,
the last power amplifier
is not connected.
Controls and Modes
input
control port
4-17