Configuring The Eq Input - Mark Levinson 32 Owner's Manual

Controls and Modes
Configuring the EQ
4-8
Note
The Nº32 offers balanced (XLR) and unbalanced (RCA) connectors. For
best performance, use balanced connections whenever possible.
2. Connect the desired N°32 input connectors to the equalizer
output connectors. This will be referred to as the EQ input.
3. Connect the desired N°32 record output connectors to the
equalizer input connectors.
4. Connect the desired Nº32 input connectors to the source com-
ponent output connectors. This will be referred to as the source
input.
Note
DO NOT
5. Reconnect the Nº32 and all associated components to electrical
outlets. Then, power the Nº32 and all associated components
on.
To configure the EQ input
Input
1. Rotate the select knob or press the select
the EQ input (the input assigned to the Nº32 input connectors
selected in step 2 of "Making EQ Mode Connections" above).
2. Press and hold the setup button until the Name parameter
appears on the front panel display.
The front panel setup LED lights when the setup menu is
displayed.
3. Press the enter button once to select the Name parameter and
access the custom names list.
The current input name blinks to indicate that a new input
name can be selected from the custom names list.
4. Rotate the volume knob or press the volume ± buttons to scroll
through all custom input names included on the custom names
list until the EQ name is displayed on the front panel.
5. When the EQ name appears, press the enter button to select
this name and activate EQ mode.
The SAVING DATA message will appear on the front panel
display to indicate that the EQ name is being saved.
Note
When the Name parameter is set to EQ, the Gain and Offset
parameters are not available for the selected input.
use the same Nº32 input connectors selected in step 2.
Mark Levinson
/ buttons to select