HI 98402 is supplied in a rugged carrying casing complete with 4 batteries, that provide up to 120 hours of continuous operation. Hanna Instruments reserves the right to modify the design, construction and appearance of its products without advance notice.
Make sure that the electrodes are not touching the bottom of the OPERATIONAL GUIDE beaker. Position the temperature probe close to the tip of the other electrodes. INITIAL PREPARATION: • Wait until the display stabilizes (about The meter is supplied with four 1.5V AA alkaline batteries. Remove the 10-15 minutes).
• Press CAL. The display will show “CAL” and “BUF” together with CALIBRATION an intermittent “~” symbol. The upper display will show the calibration point (10 ppm) with the temperature of the solution In order to obtain accurate measurements, frequent calibration is shown on the lower LCD.
The meter is factory calibrated for temperature. Note: If the reading is too far from the ® The HANNA instruments temperature probes are interchangeable expected value (in this case 0.0°C), and no temperature calibration is needed when they are replaced.
FLUORIDE ELECTRODE CLEANING ELECTRODE MAINTENANCE General: Rinse the fluoride electrode with deionized water. Protein, oil & fat: Clean the electrode tip with a cotton wool soaked PREPARATION in alcohol, then rinse with deionized water. The HI 4010 fluoride electrode is shipped dry. IMPORTANT: After cleaning, rinse the fluoride electrode thoroughly The HI 5313 reference electrode should be main- with deionized water and dry it attentively with a non-...
ACCESSORIES WARRANTY Standard Fluoride Solutions All Hanna Instruments meters are warranted for two years against defects in workmanship and materials when used for their intended purpose and main- HI 4010-00 TISAB II fluoride solution, 500 mL bottle tained according to instructions.