EPSON Stylus PHOTO 810/820
4.2.2 Printhead removal
1.
Remove the Upper housing from the printer. (Refer to Section 4.2.1)
2.
Open the Cover cartridge, and remove the both black and color ink cartridges.
3.
Remove the both Cover cartridges from the CR unit.
4.
Release two hooks for securing the Head FFC holder, and remove the Head FFC
holder from the CR unit.
Spacer FFC
Cable holder
Figure 4-5. Head FFC holder removal
Disassembly and Assembly
Hooks for Head FFC
Disassembly
5.
Remove two screws (C.B.P-TITE SCREW 3x8 F/Zn, +BIND B-TITE SEMS W2
2.5x5 F/Zb) for tightening the Printhead, and remove the Printhead from the CR
unit in the order indicated in the following figure.
2
C.B.P-TITE SCREW, 3x8, F/Zn
Figure 4-6. Printhead removal
6.
Disconnect the Head FFC from the connector on the Printhead.
Revision A
1
+BIND B-TITE SEMS, W2 2.5x5, F/Zb
87