Installation - Epson EPL-N4000 Service Manual

EPSON EPL-N4000/EPL-N4000+

4.2.33.2 Installation

1. Reinstall the two End Bearings onto the Shaft.
2. Reinstall the two Shaft Springs over the End Bearings.
3. Compress the Shaft Springs and reinstall the Shaft into the Bracket.
Make sure that the lip of each Bearing is trapped behind the tabs in
the Bracket, and that each Pinch Roll lines up with the
corresponding cutout in the Bracket.
4. Hook one end of each Holding Spring into a spring hole in one side
of the Bracket.
5. Bring the Springs over the Shaft and hook the other end of each
Spring into the spring hole on the opposite side of the Bracket.
6. Slide a Center Bearing under each Holding Spring, as shown in the
figure.
7. Reinstall the Pinch Roll Bracket onto the Left Middle Cover, as
shown in the figure.
8. Reinstall the Left Middle Cover onto the printer frame.
9. Use four screws to secure the Left Middle Cover to the printer
frame.
10. Reinstall the MSI Support Assembly. ("MSI Support Assembly" on
page -166)
Rev.B
Chapter 4 Disassembly and Assembly
179