Advertisement
<Y>
<Z>
<ClkOffset>
<TimeOf Week>
<WeekNo>
<chnlCount>
<ResetCfg>
Example: Start using known position and time.
PSRF101,-2686700,-4304200,3851624,96000,497260,921,12,3*7F
C). Set DGPS Port
This command is used to control Serial Port B that is an input only serial port
used to receive
RTCM differential corrections.
Differential receivers may output corrections using different
communication parameters.
Y coordinate position
INT32
Z coordinate position
INT32
Clock offset of the receiver in Hz, Use 0 for
last saved value if available. If this is
unavailable, a default value of 75000 for
GSP1, 95000 for GSP 1/LX will be used.
INT32
GPS Time Of Week
UINT32
GPS Week Number
UINT16
Week No and Time Of Week calculation
from UTC time
Number of channels to use.1-12. If your
CPU throughput is not high enough, you
could decrease needed throughput by
reducing the number of active channels
UBYTE
bit mask
0×01=Data Valid warm/hotstarts=1
0×02=clear ephemeris warm start=1
0×04=clear memory. Cold start=1
UBYTE
ID:102 Set PORT B parameters for DGPS input
Advertisement
