Connecting The Sewing Drive To The Table Top; General; Drive Mounting; Voltage Compensation Motor/ Machine Head - DURKOPP ADLER 8967 Installation Manual

4. Connecting the Sewing Drive to the Table Top

4.1 General

4.2 Drive Mounting

4.3 Voltage Compensation Motor/ Machine Head

8
Different drive and connections packages are available
for the machine.
The drive package consists of:
Motor, motor protection switch with wiring, belt, belt pul-
ley.
The connectios package contains all wiring between the
motor and the sewing head.
The direct current drive available for this machine is ope-
rated by a "monophase alternating voltage". Therefore,
with multiple machines, the connections must be uniform-
ly distributed to the individual phases of the mains supply
(3 phase). Otherwise, this could lead to an overload of
the individual phases.
Attention!
If the electronics are not supplied by Dürkopp Adler, then
manufacture and testing is to be conducted to EN 60204-
3-1/JEC 204-3-1.
–
Screw the drive with its base to the table top. Hereby
screw the 3 hex head M8 x 35 screws with washers
into the nuts in the table top.
–
Fasten the V-belt pulley to the motor shaft
–
Check the connections on the motor terminal board
and correct if necessary.
The arrangement must be appropriate to the mains
voltage.
–
Screw the green-yellow connecting cable found in
the enclosed package onto the motor base. It serves
to conduct the machine head static charge to ground
via the motor.