Table of Contents
Advertisement
Mute Control/Black Screen Play
●
Press the volume composite key on the panel or the MUTE key on the remote
controller to close the sound output. Press again to recover the sound output.
●
Long press of the volume composite key on the panel will close the TFT screen
display. Short press of the volume composite key on the panel will activate the
TFT screen display.
●
When TFT screen display is closed, the sound will remain the current output state.
Melody Mode Selection and Control (SEL)
● Press repeatedly the [SEL] key on the remote controller to select the melody mode
you want: volume→ bass→ high pitch→ left/right speakers→ front/rear speakers
Attention:
◆
After a target mode is selected, the current mode state can be adjusted with the
volume key.
◆
Within 3s after a certain mode is selected, if the volume button is not manipulated,
the mode will return automatically to the state before the adjustment.
◆
When QE audio effect is activated, the bass/high pitch modes won't be displayed in
pressing the [SEL] key. Namely, only volume→ left/right speakers→ front/rear
speakers will be displayed.
IV. Operation System Settings
Enter System Settings
Press [
] icon in the main interface to enter the system setting interface, you
can touch it directly to operate the setting and press Exit key to exit.
1
2
3
4
5
1. Rear View Mirror Image Function
Press [
] or [
]image icon to adjust the left/ right state of image while
backing, press Exit key to exit.
Tips: this image function only takes effect in backing state.
2. Button Buzzer Voice
Press[Buzzer] icon, you can close or open the button voice, press Exit key to exit.
5
9
8
7
6
XVI. Steering Wheel Control Button Controlling
1.Connect one or two AD cables of the main unit as required by the vehicle model.
Notes: connect a resistance (560 -1K) between key cable of 5V and one AD
Ω
cable, when connecting the control wire of steering wheel wire in the Japanese
cars and Suzuki.
2.Press [
] icon in the main interface to enter the system setting interface. Press
[Steering Wheel] icon to enter Steering Wheel Button Selection Setting. As follows:
3.Press each key of the steering wheel in your car, the above picture 1-6 will show the
corresponding voltage value. As the below picture:
.
.
0 901V
1 490V
.
.
2 705V
3 117V
.
4 Press(SET KEY) icon to defining the key function,you can set the steering
wheel key function according to your use,press(ENTER)to confrim it,then you can
use the steering wheel key to contral the machine.If the key setting is
unreasonable,you can press(RESET)to reset it.
As follows:
ADD THE KEY
SRC
PWR
.
2 294V
.
3 509V
Button Function
Select
MUTE
MODE
26
Advertisement
Table of Contents
