Gerber Sabre Owner's Manual page 73

Error
"CAN'T MOVE THE ATC DISK
TO NEW LOCATION"
"can't close the door"
"can't engage safety"
"can't grab"
"can't move arm in"
"can't move arm out"
"can't open door"
"can't release tool"
"can't send speed request"
"can't spin disk"
"can't stop spindle"
"can't turn on cone"
"can't undo safety"
"can't w84 grab"
"can't w84 release"
"**Clamp Grab Error!"
"**Clamp Release Error!"
"E2 NOT FOUND ERROR"
"E2 NOT WORKING"
"E2 TYPE COULD NOT BE
DETERMINED VALUES WILL
NOT BE SAVED"
"E2 WEAR OUT WARNING
the system will not be able
to save it's settings."
"ENCODER NOT ZERO"
"ERROR: can't talk to the
ATC Controller!"
"ERROR: Interrupt N"
"ERROR: Invalid code X"
"ERROR: Spindle speed
change failure"
Cause
ATC position movement
sensor did not get activated.
Communication lost with ATC
controller.
Clamp/unclamp detection
sensor did not activate when
expected.
Not used
Failure in nonvolatile memory.
Failure in nonvolatile memory
– could not identify the type of
non-volatile memory.
Failure in nonvolatile memory
– could not write to
nonvolatile memory.
X, Y, or Z position encoder is
not properly initialized at
power-up.
Communication lost with ATC
controller.
(This may occur even on non-
ATC jobs because ATC is used
to obtain spindle status).
An Interrupt occurred that the
firmware can't handle.
Interrupt ID is N.
Illegal G-Code command
received.
Not used.
Remedy
Check sensors and wiring.
Check disk motor and
wiring.
Check wiring.
Power cycle tower.
Check spindle clamp
sensor/wiring.
Not used
Return processor board for
repair.
Return processor board for
repair.
Return processor board for
repair.
Check encoders.
Check wiring. Power cycle
tower.
Check processor board for
hardware problems.
Verify job type is G-Code
and not "Gerber".
Use only supported G-codes.
Not used.
Error Messages 65