Grease Tray; Preventive Maintenance - George Foreman GP200C Instruction Manual

5) Use a pipe cleaner to clear obstructions from the burner holes and inlet hole. Verify
that there are no insects, insect nests or debris blocking the inlet hole. Normal wear
and corrosion may enlarge some holes, however, if large cracks or holes are found,
the burner should be replaced. (FIG 1)
Fig. 1
Note: Before reassembly of burner you may want to fully clean the grill. See CLEANING
THE GRILL section.
6) After cleaning, reassemble burner assembly and other parts in reverse order of
previous steps 2-5 disassembly.
Note: When refitting the burner, be sure to check that it is positioned correctly.
7) Check burner operation after cleaning (FIG 1).
Fig. 1

GREASE TRAY

WARNING!
• Always turn the LP gas cylinder valve "OFF" when not in use. Allow grill
to cool before handling parts or cleaning.
• Empty the grease tray after each use so excessive grease does not accumulate.
Failure to remove grease may result in a grease fire in the tray.
• Never light the LP gas grill without the grease tray in place.
• Before each use, remove all grease from your grease tray.
• Make sure grease tray is in place before use.
• Failure to remove grease from the grease cup may cause a fire hazard.
STORAGE
WARNING!
• Never store an LP gas cylinder indoors (empty or filled). If storing the gas
grill indoors, disconnect the LP gas cylinder and store it outdoors out of
the reach of children.
• Never leave an LP gas cylinder inside a vehicle which may become overheated
by the sun.
22
• Never store a spare or disconnected LP gas cylinder under or near the LP gas grill.
• Always turn off the regulator knob when not in use. Allow grill to cool before
transporting.
• Even though your LP gas cylinder may appear to be empty, gas may still be present
and the LP cylinder should be transported and stored accordingly.
• Store your LP gas grill in a cool dry place.
• Disconnect LP gas cylinder from grill and store outside, in a dry, well-ventilated
area, away from any sources of heat or ignition. Recap LP cylinder valve with the
safety cap.
• Check your LP gas grill for gas leaks, deterioration, proper assembly, and burner
obstructions before using the grill after periods of storage and/or non-use
(i.e. over winter).
PRECAUTIONS
WARNING!
• Carefully read the IMPORTANT SAFEGUARDS section at the beginning
of this manual. Make sure you understand and follow all instructions and
warnings. If you have any questions regarding this section, call
1-00-21-7 and ask for a Customer Service Representative.
• Always turn the regulator to the OFF/LOCK position when not in use.
• Allow grill to cool before handling parts or cleaning.
• Do not use aerosols or store flammable liquids or materials near this gas grill.

PREVENTIVE MAINTENANCE

Periodically check and tighten all nuts, bolts, and screws. Check if the grill works
mechanically and the grill lid locks.
EASY-CARRY SHOULDER STRAP
Note:
• Always lock the grill lid with level lock adjusters before carrying this grill.
• Do not carry the grill unless it has cooled down and has been cleaned.
Your gas grill comes with a convenient shoulder carrying strap. When the grill has
completely cooled down, and the grill and all the parts are clean:
• Return the grease tray and the regulator assembly to inside the bowl and cooking
plate on the bowl brackets.
• Fold and lock the grill lid with the level adjusters.
• Slide the strap lock back with your thumb and hook into the hole under the back
handle on each side of your grill.
• Hold the grill with one hand; place the strap over your shoulder and you are ready
to go. Adjust the strap length to fit your carrying comfort.
2