5.5 Setting
5.5.1 Lift of the Electromagnet
The lift of the electromagnet should be 20 mm.
Measured is the distance between the upper edge of the protective sleeve 4 and the
upper edge of the anchor 3 in both positions (ON and OFF). The difference must be
20 mm.
–
Loosen lock nut 6.
–
Screw anchor 3 further in or out.
–
Tighten lock nut 6 again.
5.5.2 Base Position of the Upper Thread Catchers
The forward edge 5 of the magnet must be in line with the face 2 of the machine arm.
–
Loosen screws 1 and 12.
–
Align the magnet.
–
Tighten screws 1 and 12 again.
Opener lever 13 and guide piece 11 must lie parallel to one another.
–
Loosen clamp screw 9.
–
Turn the opener lever 13 with thread catcher 10 and set parallel to the guide piece
11.
–
Tighten clamp screw 9 again.
So that the thread catcher 10 can close securely there must be a little play between the
lower part 14 of the opener lever and the movable leg 15.
–
Bring the machine into the end position (see chapter 2.2.3).
–
Screw out the stop screw 7 so far that during retreat of the opener lever before
operation of the movable leg 15 a clearance of approx. 0.3 mm is still felt between
bracket 8 and stop screw 7.
Caution Risk of Injury !
Pull the mains plug.
Make setting only with the machine turned off.
87