Installing Sata Or Sas Hard Disk Drives; Entering The Lsi Megaraid Bios Configuration Utility - Lenovo ThinkStation C30 User Manual

• The procedures described in this section are intended to guide you through a quick setup of
basic RAID functions with the LSI MegaRAID SAS adapter. For advanced setup and configuration
using this adapter, refer to the complete MegaRAID SAS Software User Guide that is available at
http://support.lenovo.com/en_US/guides-and-manuals/detail.page?DocID=UM007543.
This section provides information about the following topics:
• "Installing SATA or SAS hard disk drives" on page 76
• "Entering the LSI MegaRAID BIOS configuration utility" on page 76
• "Creating RAID volumes using the LSI MegaRAID BIOS configuration utility" on page 77
• "Deleting RAID volumes using the LSI MegaRAID BIOS configuration utility" on page 77
• "Setting the hot spare hard disk drive" on page 78

Installing SATA or SAS hard disk drives

Ensure that your computer has the minimum number of SATA or SAS hard disk drives installed for the
following supported levels of RAID:
• RAID Level 0 - Striped disk array
– A RAID Level 0 hard disk drive group consisting of at least one hard disk drive
– Supported strip sizes: 8 KB to 1 MB
– Better performance without fault tolerance
• RAID Level 00 - Spanned hard disk drive group with a series of RAID 0 hard disk drive groups
– A RAID Level 00 hard disk drive group consisting of two hard disk drives
– Supported strip sizes: 8 KB to 1 MB
– Better performance without fault tolerance
• RAID Level 1 - Mirrored disk array
– A RAID Level 1 hard disk drive group consisting of two hard disk drives
– Improved read performance and 100% redundancy
• RAID Level 5 - Block-level striped disk array with distributed parity
– A RAID Level 5 hard disk drive group consisting of at least three hard disk drives
– Supported strip sizes: 8 KB to 1 MB
– Better performance and fault tolerance
– RAID Level 5 is supported by some models of LSI MegaRAID adapter cards
Ensure that the LSI MegaRAID SAS adapter card is installed in your computer, and that the hard disk drives
are connected to this adapter card and not to the connectors on the system board.

Entering the LSI MegaRAID BIOS configuration utility

This section provides instructions on how to enter the LSI MegeRAID BIOS configuration utility.
To enter the LSI MegaRAID BIOS configuration utility, do the following:
1. During the computer startup, follow the instructions on the screen.
2. Press Ctrl+H to enter the CONTROLLER SELECTION window.
3. Select the controller you want to configure, and then click Start to enter the LSI MegaRAID BIOS
configuration utility.
76
ThinkStation User Guide