Lenovo ThinkCentre M92z User Manual page 79

3. Remove the computer cover. See "Removing the computer cover" on page 41.
4. Locate the heat sink and fan assembly for GPU. See "Locating components" on page 13.
5. Note the routing of the GPU fan cable and then disconnect the GPU fan cable from the system board.
6. Follow this sequence to remove the four screws that secure the heat sink and fan assembly for GPU
to the system board:
a. Partially remove screw
b. Partially remove screw
Note: Carefully remove the four screws from the system board to avoid any possible damage to the
system board. The four screws cannot be removed from the heat sink and fan assembly for GPU.
Figure 44. Removing the heat sink and fan assembly for GPU
7. Lift the failing heat sink and fan assembly for GPU off the system board.
Notes:
a. You might have to gently twist the heat sink and fan assembly for GPU to free it from the
microprocessor.
b. Do not touch the thermal grease while handling the heat sink and fan assembly for GPU.
8. Position the new heat sink and fan assembly for GPU on the system board so that the four screws are
aligned with the corresponding holes in the system board.
9. Follow this sequence to install the four screws to secure the heat sink and fan assembly for GPU, as
shown in Figure 44 "Removing the heat sink and fan assembly for GPU" on page 67.
a. Partially tighten screw
b. Partially tighten screw
10. Connect the GPU fan cable to the system board. See "Locating parts on the system board" on page 16.
1 , then fully remove screw
3 , then fully remove screw
1 , then fully tighten screw
3
, then fully tighten screw
2 , and then fully remove screw
4 , and then fully remove screw
2 , and then fully tighten screw
4
, and then fully tighten screw
.
Chapter 5 Installing or replacing hardware
1 .
3 .
1 .
3
.
67