Removing And Reinstalling The Frame Stand; Installing The Monitor Stand - Lenovo ThinkCentre M92z User Manual

Removing and reinstalling the frame stand

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page v.
This section provides instructions on how to remove and reinstall the frame stand.
Note: The frame stand is available only in some models.
To remove and reinstall the frame stand, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Press the release button toward the top of the computer and lift the frame stand off the computer.
Figure 11. Removing the frame stand
4. To reinstall the frame stand, align the two clips on the top of the frame stand with the two holes on
the chassis, and then press the release button toward the top of the computer until the frame stand
is secured in position.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 73.

Installing the monitor stand

Attention:
Do not open your computer or attempt any repair before reading and understanding "Important safety information"
on page v.
38
ThinkCentre User Guide