Table of Contents
Advertisement
NOTE
• Anti Shake is disabled during movie recording.
• ISO sensitivity, aperture, and shutter speed do not appear on the monitor screen
when you half-press the shutter button while "On" is selected. These values will
appear briefly, however, in the preview image that is displayed immediately after
you shoot a snapshot.
• Shooting while "On" is selected can cause an image to appear somewhat coarser
than normal and can cause slight deterioration of image resolution.
• Anti Shake may not be able to eliminate the effects of camera or subject movement
when movement is severe.
• Anti Shake may not work properly when the camera is mounted on a tripod. Turn
off Anti Shake.
Specifying the Auto Focus Area (AF Area)
Procedure
[r] (REC) * [SET] * MENU * REC Tab * AF Area
This mode takes readings of a small area in the center of the
Spot
Û
image. This setting works well with focus lock (page 57).
When you half-press the shutter button while this setting is
selected, the camera will select the optimum Auto Focus area
Multi
È
from among nine possible areas. The focus frame of the area
where the camera focuses will be displayed in green.
Half-pressing the shutter button focuses on the subject and
Tracking
Ë
causes the focus frame to track the movement of the subject.
Spot" or
"Û
Focus frame
IMPORTANT!
• Selecting "Ë Tracking" can cause vibration and noise to occur due to lens
operation while tracking a subject. This does not indicate malfunction.
Ë Tracking"
"
È Multi"
"
Focus frame
60
Advanced Settings
Advertisement
Table of Contents
