Synchronizing Spx2000 Editor - Yamaha SPX2000 Editor Owner's Manual

❏ Input Signal Setup
To open the Input Signal Setup window, choose [SPX Setup] from the [File] menu.
Input Source : Select a input source: Analog or Digital
Input Mode :
Select a input mode: Monaural or Stereo

Synchronizing SPX2000 Editor

When SPX2000 Editor starts up for the first time, the parameter settings on the SPX2000 unit and the parameter set-
tings in SPX2000 Editor be different. Therefore, you must first match the parameter settings on the SPX2000 unit
with those in SPX2000 Editor. This operation is called "synchronization." Follow the steps below to synchronize
SPX2000 Editor.
1
Choose [Re-synchronize] from the [Synchronization] menu.
The following window opens.
2
Select whether you want to transfer your settings to SPX2000 Editor, or vice versa.
At this time, the [All Libs] option determines whether or not Library data is synchronized.
[PC -> SPX2000] : Transfers the settings of the current SPX2000 Editor Session to your SPX2000 unit.
[SPX2000 -> PC] : Transfers the settings of your SPX2000 unit to the current SPX2000 Editor Session.
3
Click [OK].
Do not operate the SPX2000 unit while synchronization is in progress.
• If you use the "Total Recall" function in Studio Manager, all selected Editors in Studio Manager are
NOTE
synchronized with the corresponding devices.
• If the operation lock setting is enabled on the SPX2000 unit, parameters that are blocked will not
change on the SPX2000 unit when you operate SPX2000 Editor; this means that the parameter
settings in SPX2000 Editor and in the SPX2000 unit itself may not match.
For details on the settings that are blocked, refer to the SPX2000 owner's manual.
3
SPX2000 Editor Owner's Manual