Module Marking Labels - Dymo ILP 219 Instructions For Use Manual

• Press ENTER to select.
• The machine will now prompt you to input the step (
The display will show C C = xx, where xx defaults to 12mm or 0.5inch.
C C
• Use the cursor keys H or P to increase or decrease the settings (min. increments of 0.1 mm or 0.1 inch) until you have
reached the distance you require.
- or -
Move the cursor to the left with arrow Q to set the left-hand digits. Enter the step via the keypad.
Maximum step is 500mm or 20 inch. Minimum step is 5mm or 0.2 inch.
• Press ENTER to select. The indicator TBLOCK will be highlighted.
If one label in the list from the memory card causes an error against the available features a blank label will be printed.
2. Vertical terminal block mode
BCODE CO
• Press the key. Then use the cursor keys H or P to scroll through to the VERTICAL TERMINAL BLOCK mode:
MODE
• Press ENTER to select.
• The machine will now prompt you to input the step you wish to set as the distance between the blocks (
show C C = xx, where xx is defaulted to 6mm or 0.025 inch for the steps between your terminal blocks.
C C
• Use the cursor key to increase or decrease the settings (min. increments of 0.1mm or 0.1 inch) until you have reached the
length you require.
- or -
Move the cursor to the left with arrow Q to set the left-hand digits. Enter the step via the keypad.
Maximum step is 50mm or 2 inch. Minimum step is 2mm or 0.2 inch.
• Press ENTER to select. The indicators TBLOCK and VERT will be highlighted.
- When using files from the memory card that contain too many characters than allowed onto the label,only the amount of
characters possible will be printed.

MODULE MARKING LABELS

Module Marking Mode
Module marking mode allows you to create and print labels for electrical modules.
Every supplier of these modules has a standard length, where every module length is the length of the smallest module times
a factor X.
The meaning of this mode is to one label that will fit exactly with the total amount of modules placed in one row of a rack.
ROOM 1 HEATING
FIXED-TBLOCK
ROOM 1 LIGHT
C C ) you wish to set as the fixed distance between the blocks or ports.
C C
14
C C ). The display will
C C