5.15 Ribbon binder (class 69-373)
4
Two ribbon-binder sets are available for subclass 69-373:
sewing attachment E4:
sewing attachment E5:
Inserting the ribbon band
–
Place the ribbon band on the lower pulley of the reel holder 3.
–
Place upper pulley and pressure spring 2 on reel holder 3.
–
Screw knurled nut 1 onto reel holder 3.
The ribbon band should be kept under slight pressure.
–
Slightly raise the arm cover 6 and swivel it forwards (towards the operating side).
–
Pass the ribbon band between the guide pins 5, through the ribbon guide 4, into
the ribbon binder 8 and under the sewing feet.
–
Swivel the arm cover 6 back into place.
Adjusting the distance of the seam from the ribbon edge
–
Undo screws 7.
–
Adjust the distance of the seam from the ribbon edge as required by moving the
ribbon binder 8.
–
Tighten screws 7.
22
1
5
6
for narrow bindings
for broad bindings
Caution: danger of injury
Turn off the main switch.
The ribbon band may only be inserted with the sewing
machine switched off.
2
3
7
8