Dual XDMA6510 Installation & Owner's Manual page 8

XDMA6510 OPERATION
General Operation
Audio Press AUDIO momentarily to select between Bass, Treble,
Balance, Fader, Subwoofer and Source Volume Level.
BASS TREBLE BALANCE FADER SUBWOOFER* SOURCE LEVEL
Bass
Press AUDIO until BASS appears then rotate volume knob
left/right to adjust ( -6 minimum / +6 maximum).
Treble Press AUDIO until TREBLE appears then rotate volume knob
left/right to adjust ( -6 minimum / +6 maximum).
Balance Press AUDIO until BAL appears then rotate volume knob
left/right to adjust (BAL LEFT 12 - BAL RIGHT 12).
BAL EVEN represents equal balance
Fader Press AUDIO until FADER appears then rotate volume knob
left/right to adjust (FADER FRONT 12 - FADER REAR 12).
FAD EVEN represents equal fader
* Subwoofer Press AUDIO until SUB-W appears then rotate volume knob
left/right to adjust (0 minimum / +12 maximum).
* Note: Subwoofer option will not appear if the REAR/SUB
option in the setup menu is set to REAR. Refer to page 7 for
details.
EQ Press EQ, then turn the volume knob to cycle through the
following equalization curves: FLAT (default), POP, JAZZ,
CLASSIC, BEAT, ROCK and USER. Any manual adjustment
to the Bass or Treble settings are automatically saved as
USER.
Source Volume Level The source volume level control allows a gain adjustment
for each audio source: AM, FM, CD, AUX FRONT/REAR,
operation of iPod and USB. Set the source volume level for
each mode, depending on the relative volume of each audio
source.
To set the source volume level, press AUDIO until SRC
LEVEL appears. After one second, the current mode will
appear on the display. Turn the volume knob to adjust
the audio level of the current source (-6 minimum/+6
maximum).
Note: Only the current mode will be available for
adjustment. To adjust another mode of operation, press
MODE UP/DOWN until the desired mode is selected, then
set the source volume level for that mode.
8