Driver Removal; Crossover; List Of Spare Parts; Warranty - Tannoy Reveal X User Manual

7.0 SERVICING
6.1 Cabinet finish
To remove marks and scuffs use a soft brush. If necessary, a little warm water and detergent can
be used but under no circumstances use a solvent or abrasive cleaner.

6.2 Driver removal

Lay the cabinet on its back. Remove the six hexagonal screws and set aside. Ease the driver
from the front of the cabinet taking care not to mark the front surface. Remove the driver, note the
polarity of the internal connections and disconnect the internal wiring. Take care not to damage
the moving parts of the LF driver. To refit the driver, connect the cables from the crossover to the
LF terminals. Fit the driver into the mounting hole, making sure that the internal connecting cables
are not trapped or able to touch the LF cone. Fasten the screws finger tight and then
progressively tighten them down with the appropriate Allen key.
Repeat the same procedure for the HF driver.

6.3 Crossover

The crossover is mounted on the rear of the terminal panel. To inspect it, remove the panel by
releasing the hexagonal screws. Take care to avoid undue stress on the cables and components.
To remove the crossover completely the cables must be disconnected from the drive unit. Please
proceed as above to remove the drive unit.

6.4 List of spare parts.

PART NUMBER
9900 0529
7900 0495
7900 0457
7300 0796

8.0 WARRANTY

No maintenance of the Reveal X monitor is necessary.
All components are guaranteed for a period of five years from the date of manufacture, subject to
the absence of, or evidence of, misuse, overload or accidental damage.
For further information please contact your dealer or the distributor in your country.
If you cannot locate your distributor please contact:
Customer Services
Tannoy Ltd
Coatbridge, Strathclyde
ML5 4TF
Telephone 01236 420199 (UK)
Fax
Internet:
DO NOT SHIP ANY PRODUCT TO TANNOY WITHOUT PREVIOUS AUTHORISATION.
This warranty in no way affects your statutory rights.
DESCRIPTION
Cabinet assembly – Reveal X
Driver kit – LF – type 1690
HF unit – type1205
Crossover assembly & termination panel
01236 428230 (UK)
http://www.tannoy.com
+44 1236 420199 (International)
+44 1236 428230 (International)