Table of Contents
Advertisement
Installing Additional Memory
Figure 3 – 11 shows the memory SIMM locations.
lines:
Be sure to follow these guide-
.
The Model 735 processor board has 16–MB main memory resident (un-
removable).
.
The SIMMS must be installed as pairs (two cards of the same capacity).
.
The Model 735 has six pairs of slots (numbered 1 through 6).
.
The slot pairs on the Model 735 processor board are arranged in two
connector blocks. labeled H(igh) and L(ow). The pair numbem"ngstarts in
the middle of the board, one in each connector block.
You load the boards left to right when the board is positioned as shown
in Figure 3 – 11. Startwith the highest number H slot that will be occupied
when installing the memory cards in the new processor board (if you are
installing four pairs of cards, slot 4H is the highest number H slot). You
must then fill the lower number slots in the H block. You then fill the
lower numbers in the L block, working toward the highest number L slot
that will be filled.
.
If you need to add SIMM cards to existing SIMMS, you will need to re-
move the cards already installed in the H block, and start installing the
cards at the highest number slot to be used. The cards already installed
in the L block may remain installed; just add the new cards to the higher
numbered slots. Be sure that the SIMMS remain paired properly (two
cards of the same capacity occupying the same slot number in the H and
L blocks) when you add new cards.
3-12
Configuration
Advertisement
Table of Contents
