Installation - Alpine TDM-7582E Owner's Manual

Installation

1
Mounting sleeve
(Included)
TDM-7582E
Remove the Detachable Front Panel (refer to page
4). Slide mounting sleeve from main unit. Slide the
mounting sleeve into the dashboard.
2
Hex Nut (M5)
Ground Lead
Chassis
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (∗) already
attached to the vehicle's chassis.
Connect each input lead coming from an amplifier
or equalizer to the corresponding output lead
coming from the left rear of the TDM-7582E.
Connect all other leads of the TDM-7582E
according to details described in the
CONNECTlONS section.
Dashboard
Metal Mounting
Strap
Screw
Bolt Stud
∗
TDM-7582E
3
Lock Pin
Slide the TDM-7582E into the dashboard. When
the unit is in place, make sure the locking pins are
fully seated in the down position. This can be done
by pressing firmly in on the unit while pushing the
locking pin down with a small screwdriver. This
ensures that the unit is properly locked and will not
accidentally come out from the dashboard. Install
the Detachable Front Panel.
Removal
1. Remove the Detachable Front Panel.
2. Use a small screwdriver (or similar tool) to
push the locking pins to the "up" position
(see above drawing). As each pin is
unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the
second pin.
3. Pull the unit out, keeping it unlocked as you
do so.
<JAPANESE CAR>
TDM-7582E
Ground Lead
∗
Face Plate
Screw (M5 × 8)
(Included)
Mounting Bracket
15
-EN