Something Not Working; Troubleshooting - AEG 12710 VIT, 14710 VIT Instruction Booklet

Something not working?

If, during the spin cycle, the machine makes an unusual
whistling noise, different from the noise made by traditional
washing machines, this is due to a new type of motor.
If water is not visible in the drum, this is due to the
modern technology of new washing machines that
use less water than traditional machines.

Troubleshooting

If a problem arises, you can try to solve it yourself
following the instructions below.
If you call out an engineer when one of the following problems arises, or
to repair a fault due to incorrect use, the call-out will be charged even
if requested within the guarantee period.
During machine operation the following alarm codes may be displayed:
- E10: problem with the water supply
- E20: problem with water draining
- E40: door open
At the same time the light END flashes.
Once the problem has been eliminated, press the START/PAUSE button to
restart the programme. If after all checks, the problem persists, contact your
local AEG/ELECTROLUX Service Force Centre.
The machine does not work
38
Problem
The ON/OFF button
has not been depressed.
The main electrical or the
plug fuse have blown.
The door is not properly
closed (E40).
The plug is not connected.
The START button has not
been pressed.
The DELAY START
option has been selected.
Possible cause Solution
Depress the button.
Replace the fuse.
Close the door; the click
of the lock should be heard.
Insert the plug.
Press the button.
Check the selected delay on
the display.