Advertisement
Often you can route the sensor wires through an existing feedthrough in the
firewall.
Decide where to install the harness cable and where to connect the power
and ground leads. (Procedure 2)
Find a location inside the vehicle where you can bring together the harness
cable leads, the power and ground tap wires, the adapter cable leads, and
the sensor cable leads. The location should allow the adapter cable to reach
the DriveRight console.
Determine where to connect the digital input leads (if used). Digital input 1 is
typically used to monitor brake lights and digital input 2 is used to monitor
headlights. (Procedure 3)
Adapter Cable
Harness Cable
White
Butt Splices (3)
Sensor Support
Bracket
Display
Red
Red
In-Line
Splice
Black
Sensor
Typical DriveRight Installation
Butt
Splices
(2)
Green
Yellow
Black
Red Wire with
Fuseholder
In-Line
Splice
Red
Vehicle Drive Shaft
or CV Joint Hub
Magnet Assembly
Blue Wires
with
Digital
In-Line
Inputs
Fuses
1
2
Ground
Unswitched
+12V
Ground
Spade Terminal
Advertisement
