Adjusting Tint Of Picture; Adjusting Color Of Picture - Alpine CVA-1006 Owner's Manual

Other Useful Features
(IVA-C801)
Function buttons
(1 through 6)
1 2 3
SOURCE

Adjusting Tint of Picture

Tint adjustment can be made only in the
navigation, DVD, AUX1 and AUX2 modes.
Tint adjustment cannot be made if a Navigation
system with the RGB feature is connected.
NOTE
After carrying out the steps 1 to 3 of "To switch to the
display mode screen or to the picture mode" explained on
page 47, perform the operation described below.
1
Rotate the rotary encoder while the DISPLAY
mode screen is displayed and select "TINT" to
activate the Tint Adjustment mode. The Function
Guide is displayed.
2
Press the 1 (; GRN) button to adjust green and
press the 3 (RED :) button to adjust red. To
quickly set to the center position, press the
2 (±0) button.
3
When the tint adjustment has been completed,
press the FUNC (RETURN) button. The display
returns to the main menu screen.
NOTE
Immediately after inputting titles or changing the settings
of Setup Mode or Display Mode (While the system is
inputting the titles or data automatically) do not turn the
ignition key (engine key) to OFF.
Otherwise, the title may not be written, or the settings
may not be changed.
48
-EN
5
FUNC
Rotary encoder
(CVA-1006)
Function buttons
(1 through 6)
1 2 3 5

Adjusting Color of Picture

Color adjustment can be made only in the
navigation, DVD, AUX1 and AUX2 modes.
Color adjustment cannot be made if a Navigation
system with the RGB feature is connected.
NOTE
After carrying out the steps 1 to 3 of "To switch to the
display mode screen or to the picture mode" explained on
page 47, perform the operation described below.
1
Rotate the rotary encoder while the DISPLAY
mode screen is displayed and select "COLOR" to
activate the color adjustment mode. The
Function Guide is displayed.
2
Press the 1 (; THIN) or 3 (THICK :) button to
make the color of the picture brighter or darker
respectively to get your desired color. You can
adjust the color between MIN (–15) and MAX
(+15). When it reaches the minimum or
maximum point, the display shows "MIN" or
"MAX" respectively. To quickly set to the center
position, press the 2 (±0) button.
3
When the adjustment has been completed, press
the FUNC (RETURN) button. The display returns
to the main menu screen.
NOTE
Immediately after inputting titles or changing the settings
of Setup Mode or Display Mode (While the system is
inputting the titles or data automatically) do not turn the
ignition key (engine key) to OFF.
Otherwise, the title may not be written, or the settings
may not be changed.
FUNC
SOURCE
Rotary encoder