AEG LAVAMAT 74810 User Information page 20

Problem
E10 appears.
The END indicator
flashes 1x, and an
acoustic signal sounds
1x.
(Problems with water
inflow.)
The washing machine
vibrates when operating
or is not stable.
Washing has not been
spun.
Water is running out
from under the washing
machine.
Wash water is foaming
excessively. At the end
of the washing cycle,
the spin stops. The
OVERDOSING indicator
lights up.
E20 appears.
The END indicator
flashes 2x, and an
acoustic signal sounds
2x.
(Problems with water
inflow.)
20
Possible cause
Tap turned off.
The filter in the threaded
inlet hose fitting is blocked.
Water tap is furred with
lime scale or is faulty.
The transit packaging has
not been removed.
The screw feet not correctly
adjusted.
Only a few large items of
washing in the drum.
Screw connection on the
inlet hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
Too much detergent has
probably been used.
Kink in drain hose.
Do not exceed the
maximum pump height of
1m.
Drain pump is blocked.
For sink spigot connections:
The sink spigot is blocked.
Remedy
Turn on the tap.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Check the tap and have it
repaired, if necessary.
Removing the transit
packaging.
Adjust the feet as described
in the installation and
connection instructions.
Always load the drum as full
as possible. Mix large and
small items.
Screw the inlet hose on
tightly.
Replace drain hose.
Close the cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
Straighten the hose.
Please contact customer
service.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump.
Remove foreign bodies from
the pump housing.
Clean the sink spigot.