What To Do If; Remedying Small Faults Yourself - AEG LAVAMAT 50810 User Information

What to do if...

Remedying small faults yourself

If the programme progress display indicates one of the following fault
codes during operation:
– END flashes 1x (problem with water inlet),
– END flashes 2x (problem with water outflow),
– END flashes 4x (door open),
please consult the following table.
After the fault has been remedied, press the START/PAUSE button
In the case of other fault messages (one or more flashing indicators on
the programme progress display):
switch the appliance off and on again. Set the programme again. Press
the START/PAUSE button.
If the fault appears again, please contact your local Service Force Cen-
tre.
Problem
Washing machine does
not work.
The door cannot be
closed.
The END indicator is
flashing 4x.
The END indicator is
flashing 1x.
(Problems with the wa-
ter inflow.)
The washing machine
vibrates when operating
or is not stable.
18
Possible cause
Power plug not plugged in
or problem with the fuse.
The door is not shut proper-
ly.
The START/PAUSE button
was not pressed for long
enough.
The child safety device is ac-
tivated.
The door is not closed prop-
erly.
The tap is turned off.
The filter in the inlet hose
screw connection is blocked.
The tap is blocked by limes-
cale or is faulty.
The transit packaging has
not been removed.
The screw feet not correctly
adjusted.
Remedy
Connect the plug to a mains
socket. Check the fuse.
Close the door - there should
be an audible click.
Press the START/PAUSE but-
ton for longer.
Deactivate the child safety
device.
Close the door properly. Re-
start the programme.
Turn on the tap.
Turn off the tap. Unscrew the
hose, remove the filter and
clean it.
Check the tap and have it re-
paired, if necessary.
Removing the transit pack-
aging.
Adjust the feet as described
in the installation and con-
nection instructions.