AEG LAVAMAT 50810 User Information page 19

Problem
Washing has not been
spun.
Water is running out
from under the washing
machine.
There is a lot of foam.
The END indicator is
flashing 2x.
(Problems with the wa-
ter outflow.)
Conditioner has not
been rinsed in, com-
partment w for condi-
tioner is filled with
water.
Possible cause
Only a few large items of
washing in the drum.
The inlet hose screw con-
nection is leaking.
The outlet hose is leaking.
The drain pump lid has not
been closed properly.
Washing was caught in the
door.
The emergency drain hose is
leaking.
Too much detergent has
probably been used.
There is a kink in the outlet
hose.
The maximum pump height
of 1m has been exceeded.
The drain pump is blocked.
For sink spigot connections:
the spigot is blocked.
The conditioner insert in the
compartment for additives
has not been correctly in-
serted or is blocked.
Remedy
Always load the drum as full
as possible. Mix large and
small items.
Tighten the inlet hose.
Replace outlet hose.
Close the cover properly.
Load washing carefully for
the next wash.
Screw on the emergency
drain hose firmly.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
Straighten the hose.
Please contact your local
Service Force Centre
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
Clean the spigot.
Clean the detergent drawer,
insert the conditioner insert
firmly.
19