Remote control
Inserting Batteries
1
Open the battery compartment
cover in the direction of the
arrow.
Operation
• Aim the remote control at the remote sensor and
press control buttons to operate.
• Operate the remote control within 30° angle on
either side of the remote sensor, up to a dis-
tance of Approx. 5 meters.
NOTES:
•
Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.
•
The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote
sensor may shorten operating distance.
•
Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries
properly.
•
Do not mix old and new batteries.
•
Remove batteries if the remote control will not be operated for an extended period of time.
To bundle the connected cable
You can bundle the connected cables as follows.
1
While pressing on both
sides of the clip, remove it
from the unit while pulling
with an upward motion.
12
2
Install two "AAA" batteries
(supplied), paying attention to
the polarity diagram in the
battery compartment.
Approx. 5 meters
2
Gather up the cables
between the holes of the
cable holder.
(continued)
3
Replace the compartment
cover.
3
Replace the holder.