Lenovo ThinkCentre Edge 92z Hardware Maintenance Manual page 96

1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or other flat surface. Hold the sides of your computer and
gently lay it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See "Removing the computer cover" on page 76.
4. Locate the microprocessor on the system board. See "Locating major FRUs and CRUs" on page 65.
5. Remove the system board shield. See "Removing and reinstalling the system board shield" on page 83.
6. Remove the heat sink assembly to gain access to the microprocessor. See "Replacing the heat sink
assembly" on page 88.
7. Press the small handle
Figure 29. Opening the retainer to access the microprocessor
8. Lift the microprocessor straight up and out of the socket.
Notes:
a. Your microprocessor and socket might look different from the one illustrated.
b. Note the orientation of the microprocessor in the socket. You can either look for the small triangle
on one corner of the microprocessor or note the orientation of the notches
This is important when installing a new microprocessor on the system board.
90
ThinkCentre Edge Hardware Maintenance Manual
1 to open the retainer 2 to access the microprocessor 3 .
1
2 on the microprocessor.