Installing Or Replacing A Memory Module - Lenovo ThinkCentre Edge 92z Hardware Maintenance Manual

To replace the converter, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
3. Remove the computer cover. See "Removing the computer cover" on page 76.
4. Remove the optical drive. See "Replacing the optical drive" on page 78.
5. Locate the converter in the computer. See "Locating major FRUs and CRUs" on page 65.
6. Remove the two screws that secure the converter to the main bracket.
7. Disconnect the three cables from the converter.
8. Lift the converter off the computer.
9. To reinstall the new converter, connect the three cables to the new converter. Position the new converter
and align the two screw holes in the new converter with those in the computer.
10. Install the two screws to secure the new converter to the main bracket.
11. Reinstall the optical drive. See "Replacing the optical drive" on page 78.
12. Go to "Completing the parts replacement" on page 108.

Installing or replacing a memory module

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the Safety, Warranty,
and Setup Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to install or replace a memory module.
96
ThinkCentre Edge Hardware Maintenance Manual