Prepare The Hood - Electrolux DFKTWC75GS Use & Care Manual

10 Installation

Prepare the hood

NOTE
On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of the
hood and decorative flues, prior to final installation.
1. Remove the polystyrene block and the tape (Fig.1).
2. The back plate shown in Fig. 2 must be removed:
remove the (4) screws of the back plate, operating
from the inside of the hood (Fig. 3).
3. Remove the tape on the electrical system plate;
place the electrical system plate on the hood
(protect surface from electrical system plate using
cardboard protection). Fig. 4.
4. Remove the (2) screws of the back plate (Fig. 5)
and discard the back plate.
POLYSTYRENE BLOCK
TAPE
FIG. 1
BACK PLATE
FIG. 2
ELECTRICAL SYSTEM PLATE
PROTECTION
FIG. 3
FIG. 4
FIG. 5