Charcoal Filter; Changing The Light Bulb - Electrolux CH600-900 User Manual

Charcoal filter

• The charcoal filter should only be used if you
want to use the hood in the recirculation
function.
• To do this you will need an original charcoal
filter (available from your local Service Force
Centre).
• Replacing the charcoal filter
The charcoal filter cannot be washed nor
regenerated.
The charcoal filter should be replaced every 4
months under normal use.
Replacement filters are available from your
local Service Force Centre.
• Fitting - Fig. 4
Fit one charcoal filter on the left and one on the
right so to cover the plastic grids that protect the
fan wheel, then turn clockwise the central
handle of the charcoal filter.
• To remove proceed in the reverse order.
• Clean the inner housing using a hand hot
solution only(never use caustic detergents,
abrasive powders or brushes).
• Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the
registration plate located on the inside of the
unit.
• The charcoal filter can be ordered from your
local Service Force Centre.

Changing the light bulb

• Disconnect the cooker hood from the main
supply.
• Remove the lamp cover.
• Replace the old bulb with a new one of the
same type.
• Remount the lamp cover.
• If the light does not come on, make sure the
bulb has been inserted correctly before
contacting your local Service Force Centre.
Fig. 4
39