Table of Contents
Advertisement
Quick Links
INSTALLATION AND OPERATING
INSTRUCTION BOOKLET
WDI1210
INTEGRATED WASHER DRYER
THIS APPLIANCE COMPLIES WITH EUROPEAN DIRECTIVES
EMC 89/336/ECC
LOW VOLTAGE 73/23/ECC
ECC-LABELLING 93/68/ECC
IMPORTANT: You must read this instruction book before
installing or using this appliance and retain it for future use.
Caple Products
Telephone 0870 2411142
Facsimile 0117 982 6878
Page
1
WDI1210 user manual.doc
Advertisement
Table of Contents
Related Manuals for Caple WDI1210
Summary of Contents for Caple WDI1210
-
Page 1: Instruction Booklet
THIS APPLIANCE COMPLIES WITH EUROPEAN DIRECTIVES EMC 89/336/ECC LOW VOLTAGE 73/23/ECC ECC-LABELLING 93/68/ECC IMPORTANT: You must read this instruction book before installing or using this appliance and retain it for future use. Caple Products Telephone 0870 2411142 Facsimile 0117 982 6878 Page WDI1210 user manual.doc... -
Page 2: Installation Instructions
INSTALLATION INSTRUCTIONS Positioning After your washing machine has been placed in the desired location, level it by means of the front left foot, then the counter nut must be locked by means of the special key provided. Warning: if the machine is not perfectly leveled, it will be unstable, noisy and may lead to malfunctions and broken parts. - Page 3 machine. The external parts of the machine should never be cleaned with abrasive detergents since this would ruin the enamel coating as well as the synthetic parts. Page WDI1210 user manual.doc...
-
Page 4: Technical Features
Removing and cleaning filter Remove the plastic base guard at the bottom of the machine by pressing and pulling upwards on the two tabs. Place a rag under the washing machine to adsorb any residual water. The filter is located under the base. Turn the filter handle counterclockwise and pull out the filter. - Page 5 FUNCTIONS AND PREPARATION FOR WASHING Detergent dispenser The detergent dispenser is divided into four compartments 1. Pour washing detergent in this compartment for the prewash cycle (MAX 45 grams). 2. Washing detergent in this compartment for the wash cycle (MAX 130 grams). 3.
- Page 6 FUNCTIONS AND PREPARATION FOR WASHING & DRYING The clothes are dried by a flow of warm air made to circulate inside the drum by a fan, which gra- dually removes the damp from the clothes. This steam then condenses inside the machine when it comes into contact with the cold water. This is the reason why the water tap must remain on and the draining pipe must be positioned correctly during the drying cycle.
-
Page 7: Power Indicator
CONTROL PANEL become familiar with your machine functions, compare the symbols on the control panel with those described below. ON/OFF By pressing this button the machine turns on and executes the set wash cycle. It is used to turn the Washer Dryer on and off. POWER INDICATOR When lit, it indicates that the washing machine is electrically energized. - Page 8 TIMER DIAL Used to select the wash cycles and to display them during operation. To select the cycles, turn the dial clockwise until the mark coincides with the selected cycle. WARNING: Do not turn the timer dial while the machine is energized.
- Page 9 COTTON AND LINEN CYCLES Cycles Type of clothing Trays Thermostat Wash cycle Description to be Position Description used Very dirty To wash resistant 1-2-(3-4) 40°-95° Prewash/Wash from 40°C to fabrics and clothes 95°C - Rinse - Intermediate and final spin Dirty To wash resistant 2-(3-4)
- Page 10 WOOL CYCLES Cycles Type of clothing Trays Thermostat Wash cycle Description to be position description used 14 Wool To wash fabrics 2-(4) * -40° Wash from * to 40°C - and clothes that Rinse - require slow drum Stop with water in drum spinning 15 Rinse To rinse fabrics...
- Page 11 FITTING DÉCOR DOOR Make holes on the wooden door according to the instructions enclosed with the machine. Take hinges (A) out of the bag and fix them to the door. • Take jack (B), its support (C) and fix one to the other by means of screws (G). •...
- Page 12 Page WDI1210 user manual.doc...
Need help?
Do you have a question about the WDI1210 and is the answer not in the manual?
Questions and answers