How To Assemble - Electrolux Z9120 Owner's Manual

How to Assemble

1.
5.
ASSEMBLY PACKET
The assembly pack is with the owner's guide. The
packet contains one machine screw and nut to
fasten the handle assembly to the cleaner
ASSEMBLY
Caution: Fully assemble the cleaner before
using.
1. Open the dust bag cover. Slide the metal
portion of the handle assembly down the
channel until it fully seats on the lower
retainer. Insert the machine screw through
the housing and handle. Twist on nut and
tighten. Close dust bag cover.
2. On models with extension cords, plug
extension cord into the pigtail connection.
Secure the cord assembly into the retainers
on the back of the handle.
3. On models with direct wire cords, insert the
cord around the three retaining tabs on the
back of the handle. Give a slight pull on the
cord to secure.
4. To store the power cord, lift out the lower cord
hook and wrap the cord around the upper (11)
and lower cord hooks (12). The lower cord
hook can be stored flat on the cleaner when
not in use.
.
6.
5. The power cord can be quickly released by
pivoting the upper cord hook downward.
Return the upper cord hook to the upright
position for cord storage.
6. On models with cleaning attachments, place
the wand into the lower retainer. Make sure
the suction valve is set to the floor cleaning
position. Secure the wand into the wand
clip.
FEATURES
7. Lower Wand Retainer
8. Suction Selection Valve
9. Extension Wand and Dusting Brush
10. Wand Clip
11. Upper Cord Hook
12. Lower Cord Hook
13. Cleaning Height Adjustment
14. Brush Roll Indicator and Reset
15. HEPA Filter Assembly
16. Filter Latch
17. Power Switch
18. Dust Bag Cover Latch
19. Cord Retainer
20. Hose Retainer
21. Carry Handle
22. Handle Release
3.
11
10
9
12
8
13
7
4.
19
18
20
17
21
16
15
14
22
5