Bryant 345MAV Installation, Start-Up, And Operating Instructions Manual page 32

VENT PIPE
VERTICAL TO ROOF
Condensate trap MUST be used for all applications.
An external trap is not required when connecting the field drain to
this condensate trap.
The field drain connection (condensate trap or drain tube coupling)
is sized for 1/2-in. CPVC, 1/2-in. PVC, or 5/8-in. ID tube
connection.
Drain pipe and fittings must conform to ANSI standards and
ASTM D1785, D2466 or D2846. CPVC or PVC cement must
conform to ASTM D2564 or F493. Primer must conform to ASTM
F656. In Canada, use CSA or ULC listed schedule 40 CPVC or
PVC drain pipe, fittings, and cement.
When a condensate pump is required, select a pump which is
approved for condensing furnace applications. To avoid conden-
sate spillage, select a pump with an overflow switch.
MAINTAIN 12-IN. MINIMUM
CLEARANCE ABOVE HIGHEST
ANTICIPATED SNOW LEVEL.
MAXIMUM OF 24 IN. ABOVE ROOF.
Fig. 39—Roof Termination (Preferred)
12 MIN
HORIZONTAL TO ROOF
12 MIN
NOTE: A 12-In. minimum offset pipe section is recommended with
short (5 to 8 ft) vent systems. This recommendation is to reduce
excessive condensate droplets from exiting the vent pipe.
Fig. 38—Short Vent (5 to 8 Ft) System
ROOF
VENT
A96191
12 MIN
VENT PIPE
HORIZONTAL TO SIDEWALL
VENT PIPE
VERTICAL TO SIDEWALL
CAUTION: Unit must not be installed, operated, and
then turned off and left in an unconditioned structure
during cold weather when temperature drops to 32
degrees F and below unless drain trap and drain line have
adequate freeze protection. See Service and Maintenance
Instructions for winterizing procedures. (See Fig. 15.)
Failure to follow this caution will result in intermittent
unit operation.
VENT
90
Fig. 40—Sidewall Termination with 2 Elbows (Preferred)
—32—
12 MIN
VENT PIPE
OVERHANG OR ROOF
12 MINIMUM
MAINTAIN 12-IN.
CLEARANCE
ABOVE HIGHEST
ANTICIPATED SNOW
LEVEL OR GRADE,
WHICHEVER IS
GREATER.
A96189
A96192