Macintosh; For Usb Interface Users; 10.2.4 Or Greater) - Brother DCP-135C Quick Setup Manual

STEP 2
Installing the Driver & Software

For USB Interface Users

2
(For Mac OS
Important
Make sure that you have finished the
instructions from STEP 1 Setting Up the
Machine on pages 4 through 11.
Note
• For Mac OS
®
Mac OS X 10.2.4 or greater. (For the latest
information for Mac OS
http://solutions.brother.com)
• Make sure there are no memory cards or a USB
Flash memory drive inserted into the media drives
or USB direct interface at the front of the machine.
1
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
2
Connect the USB cable to the USB socket
marked with a
USB socket inside the machine as shown
below.
18
®
X 10.2.4 or greater)
®
X 10.2.0 to 10.2.3 users, upgrade to
®
X, visit
symbol. You will find the
3
Carefully guide the USB cable into the trench
as shown below, following the trench around
and toward the back of the machine.
Then, connect the cable to your Macintosh
Improper Setup
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your Macintosh
• Make sure that the cable does not restrict the
cover from closing, or an error may occur.
• Make sure you use a USB 2.0 cable that is no
longer than 2 metres.
4
Lift the scanner cover to release the lock
Gently push the scanner cover support down
and close the scanner cover
Note
Make sure that the machine is turned on by
connecting the power cord.
5
Turn on your Macintosh
®

Macintosh

®
.
®
.
.
.
®
.