Canon S600 Service Manual page 32

S600
Orange ---
6 blinks
Orange ---
7 blinks
Orange ---
8 blinks
User-Unresolvable Errors
Orange/ 5100 CR error
green
2 toggle
blinks
Orange/ 6000 LF error
green
3 toggle
blinks
Orange/ 5C00 Purge sensor
green
4 toggle
blinks
Orange/ 5400 Abnormal internal
green
6 toggle
blinks
Orange/ 5B00 Waste ink full
green
7 toggle
blinks
Orange/ 5200 Abnormal head
green
8 toggle
blinks
BJ cartridge not <Cause>
installed Since there is no BJ cartridge (print head)
installed, the printing and suction that were
required could not be executed.
<Suspect Part>
BJ cartridge, carriage unit
Cartridge error
<Cause>
(a) The print head temperature (output value of
(b) BJ cartridge EEPROM's checksum
<Suspect Part>
BJ cartridge
Waste-ink <Cause>
warning* 2 The total waste ink count recorded in the
EEPROM exceeds 95% of the "full" stipulated
value.
<Suspect Part>
Waste ink absorber, control board
<Cause>
The carriage's encoder signal is abnormal.
<Suspect Part>
Encoder film, carriage unit, control board, flex
cable
<Cause>
The carriage's encoder signal is abnormal.
<Suspect Part>
Encoder film, paper feed sensor unit, control
board
<Cause>
error
At the sensor's ON timing, it turns OFF. Or vice
versa.
<Suspect Part>
Purge unit, control board
<Cause>
temperature
The temperature sensor (TH401) on the control
error
board is abnormal (disconnected, etc.).
<Suspect Part>
Control board
<Cause>
error
The waste ink absorber has reached 100% of the
waste ink capacity.
<Suspect Part> Waste ink absorber, control board
<Cause>
temperature
The print head temperature (output of the diode
error
sensor in the head) is close to the threshold.
<Suspect Part>
BJ cartridge (print head), control board
2-11
the head's internal diode sensor) exceeded the
threshold.
Part 2: Troubleshooting