Canon BJC-S630 Setup Instructions

1
Unpack the Printer
1
Carefully remove all items from the box.
S630 Series
Color Bubble Jet Printer
Paper rest
Output tray
Documentation
and software kit
S630 BJ (Bubble Jet) Printhead Power cord
Ink tanks
BCI-3eC Cyan BCI-3eM Magenta
BCI-3eBK Black BCI-3eY Yellow
2
Prepare the Printer
1
Remove the shipping tape from the front
and sides of the printer.
Shipping tape
2
Plug the power cord into the back of the
printer and connect the other end to a
power outlet.
3 Press the POWER button to turn the
printer ON.
POWER POWER
button lamp
4 Open the front cover. The printhead holder
automatically moves to the center. Remove
the protective tape.
Protective tape
Serial number
5
Write down the serial number located to
the right of the printhead. You will need
this later to register the product.
Start Here
Easy Setup Instructions
3
Install the Printhead
1
Remove the printhead from its package.
2
Turn the printhead over, then remove
the orange protective cap.
NOTE: Do not touch the electrical contacts.
Electrical contacts
3 Raise the gray lock lever.
4
Slide the printhead into the holder. The
printhead will rest at a slight angle.
Do not press it down.
5 Lower the lock lever and press it down
until it locks firmly into place.
4
Install the Ink Tanks
1
Pull the orange tab off the yellow ink tank
(BCI-3eY), then remove and discard the
plastic wrapper.
2 Twist off and discard the orange
protective cap.
Protective cap
NOTE: To avoid spilling ink, never press on
the sides of an ink tank.
3
Insert the ink tank into the correct slot.
(Refer to the color guide on the printhead.)
Press down gently until the ink tank locks
into place.
4 Insert the remaining three ink tanks into
their assigned slots.
5
Close the front cover and attach the
paper rest and output tray.
Color Bubble Jet Printer
™
5
Connect the Printer
To Your Computer
For USB Cables:
1 Turn the printer off.
IMPORTANT: Be sure printer is off
before continuing, or the computer
will attempt to install the printer
driver before the printer is ready.
2
Connect one end of the USB cable
to the computer, the other to the printer.
USB port
USB cable
USB port
For Parallel Cables:
1 Turn the printer off.
IMPORTANT: Be sure printer is off
before continuing, or the computer
will attempt to install the printer
driver before the printer is ready.
2
Connect one end of the parallel cable to
the computer, the other to the printer.
(IEEE 1284 compliant)
Parallel cable
Secure
wire clips
Parallel cable
Parallel port
Continue with Step 6
on side two.