External Cleaning; Replace Light Bulb - AEG SANTO 4085-8 KG Operating Instructions Manual

Maintenance and Cleaning

External Cleaning

1
Warning!
• Do not use abrasive products
• There are sharp edges on the underside of the product so care should
be taken when cleaning.
0
1. Use a normal household stainless steel cleaner to clean the stainless
steel surface.
This cleaner simultaneously forms a protective film against finger
marks.
1
Caution: Do not allow the stainless steel cleaner to come into contact
with plastic parts, e.g. the end caps on the doors, as it will damage
them.
2
Accumulation of dust at the condenser increases energy consumption.
For this reason carefully clean the condenser at the back of the
appliance once a year with a soft brush or a vacuum cleaner.

Replace light bulb

3
For safety reasons the interior lighting switches off after 20 minutes
when the door is open. It switches on again the next time the door is
opened.
1
Warning! Danger of electrical shock! Before replacing the light bulb
switch off the appliance and remove the mains plug.
Light bulb specifications: 220-240 V, max. 25 W, fitting: E 14
0
1. To switch the appliance off press and hold both ON/OFF buttons for
about 5 seconds.
2. Unplug the mains plug.
3. To change the light bulb, undo the
cross head screw and remove the
light bulb cover downwards.
4. Change the defective light bulb.
5. Refit the light bulb cover and the
cross head screw.
38
818 18 12-01/0