Table of Contents
Advertisement
Installation
Levelling
The appliance must be level. Level the
appliance
by
adjustable feet (1) at the front of the
appliance.
If required the washer (2) can be
removed.
Reversing the Door
The side at which the door opens can be changed from the right side (as
supplied) to the left side, if the installation site requires.
Warning! When changing the side at which the door opens, the appliance
must not be connected to the mains. Remove plug from the mains
beforehand.
Carefully tilt the appliance to
the back and place an adequate
object under it.
Take
care
compressor or the condenser
touching the ground.
Unscrew the adjustable feet
situated on both sides (2
pieces), in addition the screws
fixing the lower door holders (2
pieces) respectively the screw
on the other side.
Take off the freezer door by
pulling it slightly downwards.
Unscrew the top door hinge pin
of the refrigerator then screw it
back on the other side.
Fit the freezer door on the
upper door hinge pin.
Put over the pin in the lower
door holding plate in the
direction of the arrow.
Fix the plate on the other side
leaving the position of the door
unchanged.
10
adjusting
the
two
to
avoid
the
Advertisement
Table of Contents
