Troubleshooting; Playback - Pioneer Elite BDP-62FD Operating Instructions Manual

Troubleshooting

08
Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this
component, check the points below. Sometimes the trouble may lie in another component. Inspect the other
components and electrical appliances being used. If the trouble cannot be rectified even after checking the points
below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

Playback

Problem
• Disc does not play.
• Disc tray opens
automatically.
No picture is displayed or the
picture is not displayed
properly.
Playback stops.
50
En
Check
Is the disc one that is
playable on this player?
Is the file one that is playable
on this player?
Is the disc scratched?
Is the disc dirty?
Is there a piece of paper or
sticker attached to the disc?
Is the disc properly set in the
disc tray?
Is the region number correct? See page 9 for the region numbers of discs that can be played on this
Is the video cable properly
connected?
Is the video cable damaged? If the cable is damaged, replace it with a new one.
Is the input setting on the
connected TV or AV receiver
or amplifier right?
Is the output video resolution
properly set?
• Is the player connected
with an HDMI cable other
®
/
than a High Speed HDMI
TM
cable (with a Standard
® TM
/
HDMI cable)?
• Are you using an HDMI
cable with a built-in
equalizer?
Is a DVI device connected?
Is Color Space properly set? Change the Color Space setting (page 39).
Is the HDMI Mode set
appropriately?
Remedy
Check whether the disc is one that can be played on this player
(page 7).
• Check whether the file is one that can be played on this player
(page 10).
• Check whether or not the file is damaged.
It may not be possible to play scratched discs.
Clean the disc (page 49).
The disc may be warped and unplayable.
• Set the disc with the printed side facing up.
• Set the disc properly in the depression in the disc tray.
player.
• Connect the cable properly according to the connected devices
(page 16).
• Disconnect the cable (video/audio cable or HDMI cable), then
reinsert it firmly and all the way in.
• A TV or any other device which outputs video signals must be
connected to the HDMI OUT (MAIN) terminal (page 18).
Read the operating instructions for the connected components and
switch to the proper input.
Switch the resolution at which the video and audio are output by
pressing and holding HDMI for over 2 seconds.
1080p or Deep Color video signals may not be output properly,
depending on the HDMI cable being used or the player's settings. If you
wish to output the video signals with 1080p or Deep Color, connect the
®
TV using a High Speed HDMI
then reset the player using the Setup Navigator (page 22).
The picture may not be displayed properly if a DVI device is connected.
Set the HDMI Mode to something other than Pure Audio (page 39).
• Playback may stop if the unit is subject to shocks or set in an unstable
place.
• Playback may stop when a USB device is connected or disconnected
during playback. Do not connect or disconnect USB devices during
playback.
TM
/
cable without a built-in equalizer,