Control Function; Network - Pioneer Elite BDP-62FD Operating Instructions Manual

Control function

Problem
Control function does not
work.

Network

Problem
• BD-LIVE function
(connection to the Internet)
cannot be used.
• "No valid id file found!" is
displayed when I try to update
the software.
Software updating is slow.
Check
Is the HDMI cable properly
connected?
Is the HDMI cable you are
®
/
using a High Speed HDMI
TM
Cable?
Is this player connected to
the TV using an HDMI cable
to watch the picture?
Is the HDMI Mode set
appropriately?
Is Control set to On on the
player?
Does the connected device
support the Control function?
Is Control set to On on the
connected device?
Are multiple players
connected?
Check
Remedy
To use the Control function, connect the Flat Screen TV and AV system
(AV receiver or amplifier, etc.) to the HDMI OUT terminal (page 16).
® TM
/
Use a High Speed HDMI Cable. The Control function may not work
properly if an HDMI cable other than a High Speed HDMI
used.
If video signals are being output from a terminal other than the HDMI
OUT terminal, the Control function does not work. Connect to the TV
using an HDMI cable (page 16).
• When connecting a device supporting the control function to the
HDMI OUT (MAIN) terminal, set the HDMI Mode to Dual.
• When connecting a device supporting the control function to the
HDMI OUT (SUB) terminal, set the HDMI Mode to Separate or Pure
Audio (page 39).
Set Control to On on the player (page 40).
• The Control function will not work with devices of other brands that
do not support the Control function, even when connected using an
HDMI cable.
• The Control function will not work if devices that do not support the
Control function are connected between the Control-compatible device
and the player.
• See page 16.
• Even when connected to a Pioneer product compatible with the
Control function, some of the functions may not work.
Also refer to the operating instructions for the connected device.
Set Control to On on the connected device. The Control function
operates when Control is set to On for all devices connected to the
HDMI OUT terminal.
Once connections and settings of all the devices are finished, be sure
to check that the player's picture is output to the Flat Screen TV. (Also,
check after changing the connected devices and connecting and/or
disconnecting HDMI cables.) If the player's picture is not being output
to the Flat Screen TV, the Control function may not work properly.
For details, refer to the operating instructions of the connected device.
The Control function may not work if three or more players, including
this player, are connected by an HDMI cable.
Remedy
Perform Connection Test (page 43). If "Networks is OK." is displayed,
check the proxy server settings (page 42). Also, there may be a problem
with the Internet connection. Contact your Internet service provider.
Depending on the Internet connection and other conditions, some time
may be required to update the software.
08
® TM
/
Cable is
53
En