Olivetti d-Copia 3000MF Operation Manual page 190

Error Message
Send error.
Job is canceled. Press
[End].
####
OPERATION GUIDE
Checkpoints
–
Corrective Actions
An error has occurred during
transmission. The possible error
codes and their descriptions are as
follows.
1101: The server name of the SMTP
server is not set correctly or the host
name is incorrect when sending scan
data to an FTP server. Use
EWS (Embedded Web Server) and
register the SMTP server name and
the host name correctly.
1102: The login user name is
incorrect or the domain name has not
been entered. Enter login user name,
domain name and password
correctly.
1103: The network path name is
incorrect or you do not have access
to the folder specified. Use
EWS (Embedded Web Server) and
register the path name correctly.
1104: No recipient address. Enter E-
mail address correctly.
1105: E-mail - The SMTP protocol
setting is turned off. Use EWS
EWS (Embedded Web Server) and
turn on the SMTP protocol setting.
Scan to PC (SMB) - SMB setting is
turned off. Use EWS (Embedded Web
Server)and turn on the SMB setting.
Scan to PC (FTP) - FTP setting is
turned off. Use EWS (Embedded Web
Server) and turn on the FTP setting.
1106: The sender address setting
under E-mail: SMTP is not registered.
Use EWS (Embedded Web Server)
and register the sender address.
2101, 2102, 2103, 2201, 2202, 2203,
3101: The network cable is
disconnected or the hub that it is
connected to is not operating
properly. Check the cable and the
hub. Otherwise, the server name or
the host name of the SMTP server is
not set correctly. Use EWS (Embedded
Web Server) and register the SMTP
server name and the host name
correctly.
Troubleshooting
Reference
Page
2-15
—
6
3-26
3-27
2-15
2-15
2-15
6-9