Miele W 833 Operating Instructions Manual page 30

Problem solving guide
What to do if, . . .
. . . one of the following
lights is flashing:
– "Soak/Pre-wash"
– "Main wash"
. . . the "Rinses/Rinse hold"
light flashes quickly?
. . . the "Rinses/Rinse hold"
light flashes slowly?
. . . the "Drain/Final spin"
light is flashing:
. . . the "ON" indicator light
is flashing:
. . . the washing is not spun
satisfactorily:
. . . the machine shakes
during the spin cycle:
. . . in spite of adequate
water supply the water flows
slowly into the machine:
30
Cause . . .
There is a fault.
There is a fault.
The spin speed selector has
been set to "Rinse hold".
The final spin has not taken
place. The machine detected
an imbalance.
Programme locking is activated.
There was an attempt to alter
the programme.
The spin speed selected was
too low.
The load was not distributed
sufficiently evenly in the drum.
Laundry was spun at a reduced
speed to protect the machine.
The fluff filter is clogged.
The four feet are not resting
evenly on the floor.
The filters in the water inlet
system are blocked.
Remedy . . .
Start the programme again. If
the light starts flashing again,
call the Service dept.
Select a spin speed or "Without
final spin".
–
Loosen the laundry load.
–
Turn the programme selector
to "Spin".
–
The spin speed appropriate
for the programme should be
selected.
Reselect the programme
originally chosen.
Select a higher spin speed next
time.
Mix large and small items in a
load to avoid imbalance.
Clean the fluff filter.
Level the machine (See Section
on Installation).
Clean the water inlet filters.