Miele W 970 Operating Instructions Manual page 40

Problem solving guide
What to do, if . . .
. . . the "Check (water) inlet"
indicator flashes during the
programme but the pro-
gramme is running normally.
. . . the "Check (water) inlet"
indicator flashes and the
laundry was not washed.
. . . one of the following indi-
cator lights is flashing
– "Soak/Pre-wash"
– "Main Wash"
– "Rinses"
– "Rinse hold"
40
Cause . . .
The water inlet is restricted.
The water inlet is closed.
There is a fault.
Remedy . . .
–
The stopcock is not opened
far enough.
–
The inlet hose is kinked.
–
The water pressure is too low
–
The filter in the inlet hose is
dirty. Clean it.
–
Open the stopcock.
–
Start the programme again.
–
Press "I-ON/0-OFF" button to
release it.
–
Turn the programme selector
to "Finish".
–
Press "I-ON/0-OFF" button in.
–
Re-start the programme.
–
If the indicator light starts
flashing again, call the
Service Dept.