Configuring Jmicron Jmb362 Sata Controller - Gigabyte GA-P55A-UD5 User Manual

5-1-2 Configuring JMicron JMB362 SATA Controller

A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. The JMicron JMB362 SATA controller controls the eSATA ports on the back
panel. Then connect the power connector from your power supply to the hard drive.
B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test).
Make sure eSATA Controller under the Integrated Peripherals menu is enabled (Figure 1). To create RAID,
set eSATA Ctrl Mode to RAID.
Turbo SATA3/USB3.0
Azalia Codec
PCI Express x4/x1 Slot
Onboard H/W 1394
Onboard H/W LAN1
Onboard H/W LAN2
Green LAN
 SMART LAN1
 SMART LAN2
Onboard LAN1 Boot ROM
Onboard LAN2 Boot ROM
Onboard USB 3.0 Controller
Onboard IDE Controller
eSATA Controller
eSATA Ctrl Mode
GSATA Controller
GSATA Ctrl Mode
GSATA RAID Configuration
Onboard Serial Port 1
higf : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Figure 1
[Auto]
[Auto]
[Auto]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Press Enter]
[Press Enter]
[Disabled]
[Disabled
[Enabled]
[Enabled]
[Enabled]
[RAID]
[Enabled]
[IDE]
[Press Enter]
[3F8/IRQ4]
F10: Save
- 95 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix